FCC Web Documents citing 15.213

as compiled by hallikainen.com/FccRules on 2012 01 01

• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-149A1.txt
  • Washington, D.C.'' Section 15.120 is amended by changing the Federal Communications Commission's mailing address to paragraph (d) to ``Federal Communications Commission, 445 12th Street, S.W., Washington, D.C.'' Section 15.201 is amended by revising paragraph (a) to read as follows: § 15.201 Equipment authorization requirement. (a) Intentional radiators operated as carrier current systems, devices operated under the provisions of §§ 15.211, 15.213, and 15.221, and devices operating below 490 kHz in which all emissions are at least 40 dB below the limits in § 15.209 shall be verified pursuant to the procedures in Subpart J of part 2 of this chapter prior to marketing. * * * * * Section 15.205 is amended by adding new paragraphs (d)(6) and (d)(7). § 15.205
• http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.doc http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.pdf http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-03-223A1.txt
  • be considered sufficient to comply with the provisions of this Section. The manufacturer may design the unit so that a broken antenna can be replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This requirement does not apply to carrier current devices or to devices operated under the provisions of Sections 15.211, 15.213, 15.217, 15.219, or 15.221. Further, this requirement does not apply to intentional radiators that must be professionally installed, such as perimeter protection systems and some field disturbance sensors, or to other intentional radiators which, in accordance with Section 15.31(d), must be measured at the installation site. However, the installer shall be responsible for ensuring that the proper antenna is employed
• http://www.fcc.gov/Bureaus/Engineering_Technology/Documents/bulletins/oet63/oet63rev.pdf http://www.fcc.gov/Bureaus/Engineering_Technology/Documents/bulletins/oet63/oet63rev.wp
  • specified instead of an emission limit, no emission detector is specified. Section 15.209 Section 15.205 Sections 15.215 through 15.251 Section 15.35 8 Section 15.205 The Part 15 Restricted Bands - Spurious Emissions Only 9 Part 15 low-power transmitter frequency table Frequency Band Type of Use Emission Limit Det 47 CFR 9-45 kHz Cable locating equipment 10 Watts peak output power 15.213 Any 2400/f(kHz) µV/m @ 300 m A 15.209 45-90 kHz Cable locating equipment 1 Watt peak output power 15.213 Any 2400/f(kHz) µV/m @ 300 m A 15.209 90-101.4 kHz Cable locating equipment 1 Watt peak output power 15.213 101.4 kHz Cable locating equipment 1 Watt peak output power 15.213 Telephone company electronic marker detectors 23.7 µV/m @ 300 m A